Rep: 73
2
2
I have the original GoPro hero and the attachment clips are part of the housing case which can't be replaced or removed. I was wondering if anyone had any ideas about how to reattach the clips? Is it going to have to be a glue job?
Esta é uma boa pergunta?
Rep: 195
3
1
The switched output board needs to be replaced. It could have just died, or burned out from trying to pull more than it is rated for.
Esta resposta foi útil?
That isn't related to the question.
Últimas 24 horas: 2
Últimos 7 dias: 11
Últimos 30 dias: 32
Duração total: 8,369
2 comentários
I have this problem too
por tony
The same here. Broke off in the water. :(
por Jens Van den Eede