Alterações no passo nº 2
Edição por johnsawyercjs —
Edição aprovada por Kyle Smith
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* black] Disconnect the two newly-revealed temperature sensor connectors and the fan connector from the logic board. These connectors move up, not towards the rear of the case, and can be lifted with gentle pressure from under the cable. | |
| [* icon_note] On Santa Rosa/Penryn models, there is only one temperature sensor connector containing all four leads. See second picture. | |
| + | [* icon_note] The Early and Mid 2009 models don't have a separate temperature sensor attached to the heat sink, and thus no cable for it, so nothing is plugged into the temperature sensor connector. |