Alterações no passo nº 7
Edição por Tiny Machines 3D —
Edição aprovada por Tiny Machines 3D
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [title] |
|---|---|
| + | [title] Bottom Section 1a. |
| [* yellow] Using a #1 Phillips screwdriver, remove the 11 screws on the bottom and 2 screws on each side for a total of 15. | |
| [* black] Unplug the original ribbon cable. | |
| [* black] Plug in new connections. | |
| [* violet] Ribbon Cable (keyed) | |
| [* yellow] 5V/Ground/Signal into D11 (farthest to the right with Orange wire facing the ribbon cable. | |
| [* orange] End Stop into Z+ (connection closest to the ribbon cable, right 2 pins). | |
| [* icon_note] Hot glue is optional. |