depends on configuration. This guide is for Tiny Machines 3D customers with a CANbus toolhead on a Vivedino Troodon.

For now, see https://github.com/bigtreetech/EBB/issue...

translated for others:

First of all, a great description! That helps me a lot. Great description. There should be more of those who make such an effort. Say the connection for the electric motor, I see that correctly if you classify the pins from the bottom left to the top right. EN=PD2 - STEP=PD0 - DIR=PD1 - UART=PA15 Link to the picture as I understand it https://www.gordonx.de/e-motor.jpg Can you send me the cable colors from the motor!? And the filament sensor can also be seen in your picture, a white cable on PB7 where does that come from? The filament sensor doesn't have a white cable!? A little info would be great. If not here, then feel free to email: web@gordonx.de Thank you very much.

I will look into adding another image BUT wire color should never be relied or used for pinout exclusively

Try to reboot the machine or press init sd card from print screen.

Ender 5 Pro doesn't get a special name because there is no difference between that machine and standard Ender 5 with regards to firmware.

check the link

https://github.com/InsanityAutomation/Ma...

Tiny Machines 3D is a primary sponsor in the development of our firmware, but we are not the author. Insanity Automation develops and maintains firmware for a few vendors, including Tiny Machines 3D.

The latest supported release for customers is https://github.com/InsanityAutomation/Ma... Anything newer is not thoroughly tested by Tiny Machines 3D. The process for reporting bugs, issues or concerns for any firmware outside our support is outlined below.

Insanity Automation, the firmware author, has launched a discord server in order to help manage issues and support. There is a dedicated channel, accessible only to supporters, where they can receive priority support or customization assistance as well.

Insanity Automation Discord - https://discord.gg/TKmJ85PyG4

Check the link below

Ender 5 Plus FW

Thanks for your questions. We’ve added a link to step 3.

Thanks - fixed.

Looks like you corrected it before we responded. Making a simple mistake is ok. We do link the firmware needed for this in the guide (Step 12)

Sounds like you have a wiring to firmware mismatch - 2 pin connector should be connected to Z+ like shown in Step 7 and firmware for the CR-10S Pro V2 should be used.