Alterações no passo nº 1
Edição por Tiny Machines 3D —
Edição aprovada por Tiny Machines 3D
- Antes
- Depois
- Sem alteração
Linhas do passo
| [title] Top Section 1a. | |
| [* icon_note] During this procedure, keep all fasteners as, they will be reused during re-assembly. | |
| [* yellow] Loosen socket head screws securing the X-Axis belt idler using an M3 hex. | |
| [* violet] Push the X-Axis belt idler towards the left to loosen the belt tension. | |
| [* icon_note] The X-Axis idler can also be removed | |
| [* light_blue] Remove the belt ends from the X-Axis carriage. | |
| [* icon_note] Note how the belt loops around the the tabs and re-install the same later. There is no need to fully remove the belt. Instead, just let both ends hang freely until re-assembly. | |
| - | [* orange] Loosen the fasteners holding the bottom wheel in place using the double sided wrench and M3 hex |
| + | [* orange] Loosen the fasteners holding the bottom wheel in place using the double sided wrench and M3 hex. Do not fully remove the nut. |
| [* green] Remove button screws using an M2 hex. |