Alterações no passo nº 11
Edição por Tiny Machines 3D —
Edição aprovada por Tiny Machines 3D
- Antes
- Depois
- Sem alteração
Linhas do passo
| [title] Reassembly | |
| [* green] Resecure cables to the machine | |
| - | [* |
| - | [* |
| + | [* green] Make sure you secure the cable bundle on each end of the cable chain. |
| + | [* green] Be sure to trim cable tie ends off flush so they are not sharp. |
| [* violet] This screw triggers the end stop. Make sure you position the chain so that it is clear of this screw. | |
| [* green] Reinstall bed heater connections to relay. They are not polarity specific (side does not matter) | |
| [* yellow] Tighten screw terminals |