How to Test the Manometer on a Fisher Paykel Neopuff

Tyler Lin e um outro colaborador

Última atualização em July 3, 2020

15 minutos

Moderado

Equipamento Médico

Nem o iFixit nem este guia de reparo são endossados ou afiliados ao fabricante do dispositivo médico.

Introdução

Ir para o passo 1

Please refer to page 7 of the device’s Technical Manual for source information.

Passo 1 How to Test the Manometer on a Fisher Paykel Neopuff

How to Test the Manometer on a Fisher Paykel Neopuff, How to Test the Manometer on a Fisher Paykel Neopuff: passo 1, imagem 1 %32

Lift the cover off the Max Pressure Relief Valve slightly and turn out of the way.

Editar

Passo 2

Disconnect all devices from the F&P Neopuff™/Perivent™ outlet port.

Editar

Passo 3

Check the manometer needle is within +/- 2 cm H2O of zero on the manometer gauge. If the manometer does not read zero, the resetting of the manometer to zero procedure should be followed.

Editar

Passo 4

Connect the outlet of the F&P Neopuff™/Perivent™ Infant Resuscitator to a bleed valve and a certified gauge (e.g. Mensor Digital Pressure Gauge Series 2400).

Editar

Passo 5

Set the gas supply to 10 L/min.

Editar

Passo 6

Completely close the maximum pressure limit valve by turning the left-handed knob completely clockwise.

Editar

Passo 7

With the bleed valve closed, adjust the Peak Inspiratory Pressure knob to set the pressure so that the certified gauge reads 10, 20, and 40 cm H2O.

Editar

Passo 8

Check that the manometer reads within +/- 2 cm H2O of these values at each set point.

Editar

Passo 9

With the pressure set to 40 cm H2O, open and close the bleed valve three times and check the manometer needle rises and falls smoothly.

Editar

Conclusão

If the F&P Neopuff™/Perivent™ Infant Resuscitator fails any of these tests, the manometer should be regarded as inaccurate and replaced with a new manometer.