Fujifilm FinePix T500 Motherboard Replacement

Brian Lasher e 6 outros colaboradores

Última atualização em January 10, 2025

25 - 40 minutos

Moderado

Faltando Passos

Ferramentas incorretas

Introdução

Ir para o passo 1

A device's motherboard is the center of its operations. Any problems with it will cause the device to malfunction. Depending on the severity of the damage to the motherboard, replacement may be necessary, and this guide will show you how to do that.

O que você precisa

Ferramentas

Exibir mais…

Passo 1 LCD Screen

Fujifilm FinePix T500 Motherboard Replacement, LCD Screen: passo 1, imagem 1 %32

Fujifilm FinePix T500 Motherboard Replacement, LCD Screen: passo 1, imagem 2 %32

Fujifilm FinePix T500 Motherboard Replacement, LCD Screen: passo 1, imagem 3 %32

Unscrew the six 3.5mm Philips head from the outer casing.

Editar

Passo 2

Fujifilm FinePix T500 Motherboard Replacement: passo 2, imagem 3 %32

Open the battery compartment and remove the battery.
Carefully pry the front half of the casing away from the camera.
Pay close attention to the sensor cover—a small piece of translucent plastic—as it may fall out of place. If it does, place it back in its original position.

Editar

Passo 3

Pry the back half of the casing from the camera.
Be careful when maneuvering the camera without the casing on as the LCD screen is not fastened to anything.

Editar

Passo 4

Fujifilm FinePix T500 Motherboard Replacement: passo 4, imagem 3 %32

Lift the LCD screen out of the camera.
Locate the tab securing the ribbon cable that connects the screen to the motherboard. Using a spudger, gently lift the tab to release the ribbon. Carefully disconnect the screen from the motherboard.

Editar

Passo 5 Lens

Fujifilm FinePix T500 Motherboard Replacement, Lens: passo 5, imagem 1 %32

Unscrew the 3.5 mm Phillips head screw from the corner of the camera.

Editar

Passo 6

Fujifilm FinePix T500 Motherboard Replacement: passo 6, imagem 3 %32

Pry off the center casing of the camera. Separate the top and side sections individually before fully removing the casing.

Editar

Passo 7

Fujifilm FinePix T500 Motherboard Replacement: passo 7, imagem 3 %32

Unscrew the two 3.5 mm Phillips head screws in the metal plate.

Editar

Passo 8

Pry the metal plate out using the spudger.

Editar

Passo 9

Fujifilm FinePix T500 Motherboard Replacement: passo 9, imagem 3 %32

Peel back the strip of black tape to reveal a red and black wire.
Detach the orange ribbon by gently pulling on it.
Detach the golden ribbon by gently lifting it with the spudger.

Editar

Passo 10

The lens should now be free to simply be pushed out of its socket.
The black and red wires that were exposed previously may be in the way of removing the lens and may break. If they do, you will need to solder these wires back into place upon reassembly.

Editar

Passo 11 Motherboard

Fujifilm FinePix T500 Motherboard Replacement, Motherboard: passo 11, imagem 1 %32

Ferramenta utilizada neste passo:

Tweezers

$4.99

Adicionar ao carrinho

Use tweezers to pull back the plastic covering the top of the camera.

Editar

Passo 12

Use tweezers to disconnect both the red and the black wires located next to the flash of the camera.
These wires will need to be soldered back in place upon reassembly.

Editar

Passo 13

Pry off the top circuit board using the spudger.

Editar

Passo 14

Use tweezers to disconnect the blue and white wires on the underside of the camera.
These wires will need to be soldered back in place upon reassembly.

Editar