Introdução

In order to switch the stitching styles of your sewing machine, the stitch select knob must be properly functioning. This guide will show the steps for replacement.

Peças

Não são necessárias peças.

  1. Place the machine on a solid surface.
    • Place the machine on a solid surface.

    • Remove the 14mm Phillips #2 screw holding on the face cover.

  2. Remove the two 14mm Phillips #2 screws and two 22mm Phillips #2 screws that secure the rear casing.
    • Remove the two 14mm Phillips #2 screws and two 22mm Phillips #2 screws that secure the rear casing.

  3. Lay the machine on its side.
    • Lay the machine on its side.

    • Remove the four 10mm Phillips #2 screws that hold the bottom panel in place.

    • The feet will come off with the screws.

  4. Free shipping on all orders over US$100,00 or containing a Pro Tech Toolkit!

    Visite Nossa Loja
  5. Remove the bottom panel.
    • Remove the bottom panel.

  6. Place the machine upright.
    • Place the machine upright.

    • Remove the rear casing.

    • You may have to wiggle the panel and pull at the same time.

  7. Adjust the knob to gain access to the phillips head screw.
    • Adjust the knob to gain access to the phillips head screw.

  8. Remove the 14mm Phillips #2 screw.
    • Remove the 14mm Phillips #2 screw.

  9. Remove the knob.
    • Remove the knob.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Kevin Bickers

Member since: 05-02-2014

601 reputação

4 Guides authored

Equipe

Cal Poly, Team 2-12, Amido Winter 2014 Membro de Cal Poly, Team 2-12, Amido Winter 2014

CPSU-AMIDO-W14S2G12

4 Membros

6 Guides authored

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 11

Todo: 509