It's hard to find it, but I suggest you to make it yourself if you've searched all the sites and can't find it. I know it seems very difficult, but it can be done, or you can find these screws in old radios or old sound recorders and replace them. change the
Remove the horn and clean its electronic parts well with salt injector spray, and if your horn model has mechanical parts, grease it with grease or lithium soap-based oil, then install it. If the problem is not solved, it is possible that some electronic parts are damaged. Test and replace if possible
You have to open the screws and remove the laptop keyboard cover and then see if the mouse pad switches work or not, it may be caused by dirt and dust.
If you can open the front and back cover of the printer and find the gears that are related to pulling the paper in and out, and then turn them slowly, maybe your problem will be solved and make sure that the printer is not powered while doing so. this
Hello, if you can't find the screw model in the product manual, I have a good solution for you, get a caliper and then measure the depth of the screw hole and the size of the opening of the screw thread. This is how you can get the right screw
You may not have properly connected the monitor cables to your case, or the monitor wire is damaged, or the ports at the beginning and end of the cable are damaged, or the connection socket of the case or monitor itself is damaged, so it must be healthy. Make sure these
First, make sure the health of your adapter and then check the wire so that it is not damaged anywhere, if it is correct, check the power supply of your monitor.
It is possible that one of the diodes or resistors was damaged when you installed the RAMs and they burned. The best thing to do is to test the resistance and voltage of all parts of your motherboard.