Adjusting Singer Brilliance 6180

Passo 1 — Needle Position

If the position of the needle is not correct, some errors will occur, which can make the user very annoyed.

Passo 2 — Remove left cover

To access the adjustment plate and screw, you need to remove the left cover.

Passo 3 — Method 1: Adjusting the needle carrier

The needle carrier is attached at the top with a 2 mm Allen screw. Loosen the screw to slightly move the cantilever. It's pretty tight the first time, be careful.

Passo 4 — Method 2: Adjusting the Needle Carrier

The cantilever slides past a plate. You can adjust the position of the needle by slightly bending this plate.

Passo 5

The adjustment plate is fixed with a Phillips screw. Gently twist it out.

Passo 6

Push the needle carrier a little forward from behind to relieve the adjustment plate, then simply lift it up using a pair of tweezers.

Passo 7

This is what the setting plate looks like. It regulates the position in sewing direction.

Passo 8 — Adjust lateral shift

The lateral position of the needle is easier to adjust. A black banjo bolt is used for this purpose. This position is set at the factory and does not normally need to be readjusted.

Passo 9 — Tip

One last hint: sewing starts better if you lower the needle using the handwheel into the throat plate after each switch-on; the motors adjust themselves with a brief click. Lift the needle up again and you're good to go - until the next time you turn it off.