Aviso: Você está editando um guia tipo pré-requisito. Todas as alterações que você fizer afetarão todos os 6 guias que incluem este passo.
Traduzindo o passo 1
Passo 1
-
When separating the sides of the screen assembly from the device's frame, you will need to release five metal clips securing it in place.
-
Three of these clips are located on the left side of the device, and two are located on the right side.
-
You will need to work around these clips with your opening pick in order to fully release them.
-
You can either carefully slide an opening pick around these clips, or leave a pick on one side of the clip while prying the other side with another pick.
| - | [* black] Using the flat end of the nylon spudger, pull off the black tape on top of the screen connector piece that the black ribbon is attached to. |
|---|---|
| + | [* red] When separating the sides of the screen assembly from the device's frame, you will need to release five metal clips securing it in place. |
| + | [* orange] Three of these clips are located on the left side of the device, and two are located on the right side. |
| + | [* black] You will need to work around these clips with your opening pick in order to fully release them. |
| + | [* black] You can either carefully slide an opening pick around these clips, or leave a pick on one side of the clip while prying the other side with another pick. |
Suas contribuições são licenciadas pela licença de código aberto Creative Commons.