At the top of the screen, near the center will be the inverter. On the left is the power cable and on the right is the backlight power source.

Power supply

Backlight power source

Carefully pull the connectors out of the inverter. Do not pull on the wires, only the plastic connector. It may take a bit of maneuvering to get a solid grip on them.

Holding the power supply and video cable in place are two strips of tape. Carefully peel them off, and then lift the cables up. The old screen can now be removed and the new screen installed.

Upon reinstallation the cables must be taped down again. If the original tape no longer holds, you can use masking tape.