Alterações no passo nº 6
Edição por Yash Chari —
Edição aprovada por Yash Chari
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* yellow] This is where the fan is located. Carefully remove the fan from its slot. | |
| - | [* |
| + | [* icon_note] ***Note:*** At this stage, you may remove the pin connector of the fan from the printed circuit board. However, it may be difficult to pull the pin. We recommend removing the printed circuit board for more clearance during removal. |
| [* red] Remove the screws on the printed circuit board using the same PH1 driver. |