Alterações no passo nº 1
Edição por Matt Steensma —
Edição aprovada por Matt Steensma
- Antes
- Depois
- Sem alteração
Linhas do passo
| + | [* black] Locate the joystick assembly near the top right corner of the motherboard. |
|---|---|
| [* red] Remove the two 8mm Phillips #00 screws from the back of the joystick. | |
| - | [* black] Use the flat end of the Spudger to pry off the |
| - | [* black] Lift the joystick pad and place it on its back |
| + | [* black] Use the flat end of the Spudger to pry off the joystick pad from its plastic housing. |
| + | [* black] Lift the joystick pad and place it on its back. Be careful not to pull on the ribbon cable. |