Alterações no passo nº 3
Edição por Oneika White —
Edição aprovada por Kristen Gismondi
- Antes
- Depois
- Sem alteração
Linhas do passo
| [title] Wires and Soldering | |
| - | [* black] The speaker is connected to the main board by two soldered wires. The location on the circuit board is highlighted in the image on the left. |
| - | [* black] Before you can replace the speaker, you must desolder the wires connected to the old speaker. You can now solder the wires on to the new speaker. The polarity (+ or -) of the wires is not important, so it is okay if you swap them. |
| + | [* black] The speaker is connected to the main board by two soldered wires. The locations of the each soldered wire are circled in red on the image to the left. |
| + | [* black] De-solder the wires to the old speaker and set it aside. |
| + | [* black] Solder the wires onto the new speaker. |
| + | [* icon_note] The polarity (+ or -) of the wires is not important, so it is okay if you swap them. |