Histórico do passo nº 1 do guia JD Razor 2000 Front Wheel Replacement

-	[title] Removing the ~~Screw~~
+	[title] Removing the 1.75" Axle Bolt
	[* red] Orient the scooter so that the front wheel is facing you. Observe the right and left side of the wheel. Remember which is which throughout the guide.
-	[* orange] Using an Allen wrench, unscrew the ~~screw~~ slowly from the right side while applying a constant pressure with your hand on the left side of the ~~screw~~.
-	[* icon_note] If the left side of the ~~screw~~ turns while you unscrew the right side, you will need to use a second Allen wrench to prevent it from moving
-	[* icon_note] If the ~~screw~~ does not move at all, or moves very little, try applying a lubricant on as much of the screw as possible and try again in 5 minutes.
-	[* yellow] Carefully pull apart the ~~screws~~ from ~~the left and right~~ side of the wheel.
+	[* orange] Using an Allen wrench, unscrew the axle bolt slowly from the right side while applying a constant pressure with your hand on the left side of the bearing.
+	[* icon_note] If the left side of the bolt turns while you unscrew the right side, you will need to use a second Allen wrench to prevent it from moving
+	[* icon_note] If the bolt does not move at all, or moves very little, try applying a lubricant on as much of the screw as possible and try again in 5 minutes.
+	[* yellow] Carefully pull apart the bolt and bearing from either side of the wheel.