Alterações no passo nº 5
Edição por Zack McCauley —
Edição recusada por Jake Devincenzi
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* black] Simultaneously push the two plastic clips on the far left and right sides of the I/O board toward the middle of the I/O board and pull the I/O board slightly away from the outer case. | |
| [* icon_caution] Pull the I/O board/logic board assembly out of the outer case a maximum of 5 mm. Pulling the assembly out further may damage the IR sensor connector (highlighted in red in the third picture). | |
| + | [* black] Tip: Carefully lift the thermal sensor for the Optical Drive, and the IR sensor wire in addition to the hard drive thermal sensor wires, to prevent accidental damage to both sensor wires and/or the logic board. It is easier to prevent than to repair or replace. (both visible in third picture, highlighted in red and adjacent to red box) |