Alterações no passo nº 4
Edição por Andrew Bookholt —
- Antes
- Depois
- Sem alteração
Linhas do passo
| + | [* icon_note] For enough clearance to remove the hard drive, the logic board must be slightly removed. To accomplish this, two cylindrical rods must be inserted into the holes highlighted in red. |
|---|---|
| + | [* icon_caution] Inserting instruments into any logic board holes other than the ones highlighted in red may destroy the logic board. |
| + | [* black] Insert two tools having a maximum diameter of 2.5 mm into the holes highlighted in red. Be sure they make contact with the outer case below the logic board before proceeding. |
| + | [* black] Carefully pry the tools toward the I/O board. The logic board & I/O board assembly should slightly slide out of the outer case. |
| + | [* black] Cease prying when the I/O board is visibly separated from the outer case. Remove the two tools. |
Imagem 1
Nenhuma imagem anterior
Adicionado
Imagem 2
Nenhuma imagem anterior
Adicionado
Imagem 3
Nenhuma imagem anterior
Adicionado