Alterações no passo nº 11
Edição por Mehboob —
Edição aprovada por Geoff Wacker
- Antes
- Depois
- Sem alteração
Linhas do passo
| + | [* black] This is the empty body of the Magic Bullet with the motor removed. |
|---|---|
| + | [* light_blue] There are three white plastic posts inside, which slide down when the jar is attached. There is a spring at the bottom of each post to push it back up when the jar is removed. |
| + | [* light_blue] The posts have tabs on the bottom, one of which engages with the micro-switch on the motor. |
| + | [* red] The posts can get jammed if some liquid spills inside the body, since it is impossible to clean the sliding area of the posts. |
| + | [* black] To remove the posts, the black plastic strip on the top edge of the body has to be removed. |
| + | [* orange] Since the black strip is glued on to the body, the easiest way to get it free is to dip it in boiling water. |
| + | [* black] Wait for a few minutes and then pry it off. Keep pulling up hard all round the edge and it will come off with a bit of force. |
| + | [* black] Here is the body with the black strip and the three white posts. The springs at the end of the posts in my Bullet were all rusted off. |
Imagem 1
Nenhuma imagem anterior
Adicionado
Imagem 2
Nenhuma imagem anterior
Adicionado
Imagem 3
Nenhuma imagem anterior
Adicionado