Alterações no passo nº 5
Edição por Emmett Normand —
Edição aprovada por Emmett Normand
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* red] Remove the |
|---|---|
| + | [* red] Remove the 20mm PH0 head screw. |
| [* orange] Disconnect the DC connector. The DC connector can be identified as the connector with only two wires. | |
| [* yellow] Disconnect the power button. It is a temporary switch, which can be identified by its 4-wire configuration. | |
| [* green] Disconnect the Hall effect sensor. It can be identified by its 6-wire configuration. | |
| [* icon_note] A hall effect sensor is used to tell the board where the motor is in its rotation. | |
| - | [* icon_caution] You will |
| + | [* icon_caution] You will need to remove silicone and hot glue to remove the connectors. |