Alterações no passo nº 5
Edição por Emmett Normand —
Edição aprovada por Emmett Normand
- Antes
- Depois
- Sem alteração
Linhas do passo
| + | [* red] Remove this Phillips head screw |
|---|---|
| + | [* green] Disconnect the DC connector it can be identified as having only 2 wires |
| + | [* orange] Disconnect the power button it is a temporary switch and can be identified as having 4 wires |
| + | [* blue] Disconnect the Hall effect sensor it can be identified by having 6 wires. A hall effect sensor is used to tell the board where the motor is in its rotation. |
| + | [* icon_note] You will most likely need to remove silicone and hot glue to remove the connectors |
Imagem 1
Nenhuma imagem anterior
Adicionado