Alterações no passo nº 1
Edição por Emmett Normand —
Edição aprovada por Emmett Normand
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* black] Flip the skateboard back over. | |
| - | [* red] Remove the 6 22mm bolts indicated on the top side of the skateboard with a 3mm allen wrench. |
| - | [* orange] While holding the nut from the underside of the skateboard remove the 4 32mm bolts with the 3mm allen wrench. |
| - | [* black] After removing these bolts, you can |
| + | [* red] Remove the (6) 22mm bolts indicated on the top side of the skateboard with a 3mm allen wrench. |
| + | [* orange] While holding the nut from the underside of the skateboard remove the (4) 32mm bolts with the 3mm allen wrench. |
| + | [* black] After removing these bolts, you can seperate the trucks and control module from the board. |