Ir para o conteúdo principal

Alterações no passo #2

Edição por Noel

Aguardando aprovação

Antes
Depois
Sem alteração

Linhas de Passo

-[* icon_caution] The upper case is constructed of rubber-coated aluminum. Do not excessively bend the aluminum during removal, as any permanent deformation will cause tolerance issues after reassembly.
+[* icon_caution] The lower case is constructed of rubber-coated aluminum. Do not excessively bend the aluminum during removal, as any permanent deformation will cause tolerance issues after reassembly.
[* black] Slightly lift the lower case near the vent opening.
[* black] Continue running your fingers between the lower and upper cases until the upper case pops off its retaining clips.
[* icon_note] The location of these three clips is shown in the third picture.