Alterações neste passo
Edição por Mario Pecoraro —
Edição recusada por Walter Galan
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* icon_caution] Before disconnecting the thermal sensor cable, take note of its orientation. It is extremely important to reinstall the connector in the current orientation so the fans will not run at full speed. If you have multiple pins on your replacement hard drive, put the connector closest to the SATA connections and closest to the PCB board. |
|---|---|
| + | [* icon_caution] Before disconnecting the thermal sensor cable, take note of its orientation. It is extremely important to reinstall the connector in the current orientation so the fans will not run at full speed. If you have multiple pins on your replacement hard drive. |
| + | [* icon_note] Remember for the reinstall. Put the connector closest to the SATA connections and the dark wire ( on top ) closest to the PCB board. If you fan is spinning like a jet engine, chances are its this connector. Just flip it and this should fix it. |
| [* black] Disconnect the thermal sensor, SATA power, and SATA data cables by pulling their connectors away from the sockets on the hard drive. |