Alterações no passo nº 8
Edição por Karyn McBurney —
Edição aprovada por Karyn McBurney
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* black] Insert wisdom here. |
|---|---|
| + | [* black] Dry fit the new piece into position (don't attach yet). It should be flush with the existing ceiling, rest on half a ceiling rafter on each side, and have a slight gap around the edges (trim the new piece or the existing ceiling edges if you need more room on a rafter to affix it securely). Pic 1. |
| + | [* black] Once trimmed, slide the new piece into position. Use the framing square and pencil to draw a line from the trim arrow to the ceiling arrow you marked in Step 4. Follow this line to affix the new piece to the middle ceiling rafter; ***continue to support the new piece until at least three screws firmly attach the new piece to the rafter.*** Pic 2. |
| + | [* black] Attach the new piece to the rafters on each side, placing the screws a little back from the edge as before and angled slightly into the rafter. Anchor both sides with screws spaced evenly from corner to corner. When the new piece is ***fully secured***, remove the supporting trim and patch the screw holes with joint compound, if noticeable. Pic 3. |