Alterações no passo nº 2
Edição por Tarun Thiruma —
Edição aprovada por Tarun Thiruma
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* black] Slide the opening pick along the edge of the battery to loosen the adhesive. | |
| - | [* icon_note] The adhesive which holds the battery in place is soft. However if you're struggling to pry out the battery you can place a [guide|25705|heated iOpener|new_window=true] on the rear side of the watch to loosen the adhesive. Apply the iOpener for at least two minutes. |
| + | [* icon_note] The adhesive which holds the battery in place is soft. However, if you're struggling to pry out the battery you can place a [guide|25705|heated iOpener|new_window=true] on the rear side of the watch to loosen the adhesive. Apply the iOpener for at least two minutes. |
| [* black] Use constant, steady pressure to slowly pry the battery up, separating it from the adhesive securing it to the system board. | |
| [* icon_caution] Mind the display cables and especially the force touch cable which covers the battery in one corner so you don't damage them when levering the battery out. | |
| [* icon_caution] Make sure you don't puncture or deform the battery, as it can catch fire and/or explode if damaged. | |
| [* icon_caution] Don't try to remove the battery all the way yet. It is still connected to the watch assembly. |