Alterações no passo nº 3
Edição por Tarun Thiruma —
Edição aprovada por Tarun Thiruma
- Antes
- Depois
- Sem alteração
Linhas do passo
| [title] Cut the Display Adhesive | |
| [* black] Apply a suction cup to the display, near the middle of the right edge. | |
| [* black] Pull up on the suction cup with firm, constant pressure to create a slight gap between the display and rear case. | |
| [* icon_note] If the screen is cracked, the suction cup may not stick. [https://d3nevzfk7ii3be.cloudfront.net/igi/4MmKE22Cy2MavVZU|Try lifting it with strong tape|new_window=true], or superglue the suction cup in place and allow it to cure so you can proceed. | |
| [* black] This may require a significant amount of force, but you only need to open a very slight gap with the suction cup to insert your tool. | |
| [* black] If you have trouble, apply more heat to further soften the adhesive, and try again. The adhesive cools quickly, so you may need to heat it repeatedly. | |
| [* black] Insert an opening pick (or playing card) into the gap you opened behind the display. | |
| - | [* icon_caution] Do not insert the tool more than 1.5 mm past the edge of the display. |
| + | [* icon_caution] Do not insert the tool more than ~1.5 mm past the edge of the display. |