Scentsy Warmer Light Bulb Replacement

Última atualização em September 14, 2023

30 - 45 segundos

Fácil

Introdução

When your light bulb wears out and your Scentsy warmer doesn’t melt the wax as well as they are supposed to, then it’s time to replace the light bulb. It depends on the warmer that you have, different Scentsy warmers take light bulbs with different wattage. Using a light bulb with a lower wattage can result in the wax not being melted all the way. Using a light bulb with a higher wattage can be dangerous and potentially damage your warmer. Therefore, I recommend you use a light bulb with the correct wattage.

O que você precisa

Peças

Scentsy Light Bulb À venda em outro site
Visualizar

Ferramentas

No tools will be needed to complete this guide.

Passo 1 Light Bulb Replacement

Scentsy Warmer Light Bulb Replacement, Light Bulb Replacement: passo 1, imagem 1 %32

Unplug the device's power cord from the electrical outlet.
If the warmer was running before you turn it off and unplug the device from its outlet, wait for the warmer to cool down (approximately 15 minutes) before you continue to the next step.

Editar

Passo 2

Remove the wax warmer dish from the device.

Editar

Passo 3

Carefully unscrew the light bulb from its socket in a counterclockwise direction.
Remove the light bulb from the device.

Editar

Passo 4

Check the wattage of the light bulb at the bottom of the device.
Make sure you have the correct wattage for the new light bulb in hand to replace the old one with.

Editar

Passo 5

Screw in the new light bulb in a clockwise direction.

Editar

Passo 6

Place the wax warmer dish back on top of the device.

Editar

Passo 7

Plug the power cord back in to the electrical outlet.

Editar

Passo 8

Add in a few cubes of wax.
For a mid size or larger warmer such as this one, use two cubes at a time, at the most. For a smaller size warmer, you only need one cube at a time. Adding more than the suggested cubes of wax to a warmer could lead to the wax not being melted all the way.
Turn the device on.
Make sure the device is powering on by observing the light indication.