Rubber Watch Battery Replacement

Última atualização em February 25, 2025

20 minutos

Moderada

Introdução

This guide is designed to help you replace the battery of a screw-less rubber watch. With this guide, we hope that this will help preserve the life of a watch designed to be disposable. You will need to use an X-acto knife, a very sharp knife that should be handled with caution. You will also need a spudger or something flat and non-metal, something like the wooden coffee stick we use here, to take out the battery.

O que você precisa

Peças

LR920 Battery
Link de afiliado
Disponível em Amazon
Visualizar

Ferramentas

Exibir mais…

A iFixit ganha comissão quando você compra por estes links.

Passo 1 Battery

Rubber Watch Battery Replacement, Battery: passo 1, imagem 1 %32

Rubber Watch Battery Replacement, Battery: passo 1, imagem 2 %32

Begin by placing the watch on its backside.

Editar

Passo 2

Rubber Watch Battery Replacement: passo 2, imagem 3 %32

Gently pull the top of the watch's back until the cap detaches, in a peeling motion.
Pull out the white cap and green chip once it is free.

Editar

Passo 3

Carefully puncture the plastic casing next to the battery on top of the green chip with the X-Acto knife and stop.
Be careful not to insert the X-Acto knife too downward into the battery.

Editar

Passo 4

Rubber Watch Battery Replacement: passo 4, imagem 3 %32

Flip the chip around to the front.
In a chiseling motion, make an incision on the front side above the battery to cut out a plastic casing.
Make sure to hold the knife away from the hands in a safe, stable grip.
Remove the cut plastic casing over the battery.
The plastic casing should come off like a cap.

Editar

Passo 5

Gently remove the battery with a spudger or a wooden coffee stick.
Using too much force may detach the tab holding the battery and break the watch.
Once free, remove the dead battery.

Editar

Passo 6

Insert the new battery.
Place the cut plastic cap casing over the chip and battery.

Editar

Passo 7

Rubber Watch Battery Replacement: passo 7, imagem 3 %32

Place the white cap over the green chip.
Insert the white cap and green chip into the back of the watch with the spudger or wooden coffee stick.
Turn over the watch and check the power.