How to Replace a Watch Strap

Última atualização em January 4, 2016

10 minutos

Fácil

Introdução

Millions wear watches everyday as a useful accessory. Most of the value in watches is in the body and mechanisms, not in the strap. A cheap watch strap failure can make an expensive watch useless if not repaired. Save money on watch repairs or make your watch more fashionable by reading this guide.

O que você precisa

Peças

Ferramentas

Spring Bar Removal Tool
Link do afiliado
Disponível no/na Amazon
Visualizar

Exibir mais…

A iFixit ganha comissão quando você compra por estes links.

Passo 1 Watch Strap

How to Replace a Watch Strap, Watch Strap: passo 1, imagem 1 %32

Begin by laying a soft towel or fabric on a table.
This will prevent accidental scratches during the repair.
We will be performing all repairs from the back of the watch, to avoid scratching the visible watch face.

Editar

Passo 2

Before you begin, consider practicing with your tool to compress the bar.
Hold the watch with the face in your palm, with one end of the strap free to move.

Editar

Passo 3

Insert your Spring Bar tool into the gap between the end of the watch strap and the watch body.
Press down and compress the spring. By pushing the bar away from the body, one end of the spring bar should come loose.

Editar

Passo 4

Being cautious as to not damage the body or spring bar, slide the bar out from its hole and remove the strap.
Set this half of the strap with the spring bar aside until we remove the other strap.

Editar

Passo 5

How to Replace a Watch Strap: passo 5, imagem 3 %32

Repeat steps 2-4 to remove the other end of the watch strap.

Editar

Passo 6

How to Replace a Watch Strap: passo 6, imagem 3 %32

Replace the old or damaged watch straps by simply sliding the spring bars out and into the new straps
Be careful not to put the new straps on the wrong side of the body.

Editar

Passo 7

How to Replace a Watch Strap: passo 7, imagem 3 %32

Begin the reassembly by sliding the bottom of the spring bar into its hole on the watch body.
Remember, always work from the back of the watch to prevent visible scratches.
Using your spring bar tool, compress the bar and slide back into place.
The spring bar should click when installed correctly.