Headphone Jack/Microphone and ear speaker not working

Question

iPhone xr

4994 Perguntas Visualizar todos

Niall @borderphones

Rep: 375

6

10

1

Postado: 28 de dez de 2016

Opções

Headphone Jack/Microphone and ear speaker not working

Having strange problems with an iPhone 6.

Calls can only be heard through speaker whilst nobody can hear me. Microphone not working even with voice memos. Speaker works fine but if plug in headphone continues to play through speaker. Have replaced charge port and still same issues. Any advice? Know phone recently had a new screen replaced by another tech if that could have caused issues.

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não

Pontuação 3

Adicionar um comentário

3 respostas

Solução escolhida

Minho @refectio

Rep: 221,4 mil

15

289

807

Postado: 28 de dez de 2016

Opções

I would check for Long-Screw Damage, just in case.

There are three microphones on the iPhone 6. There is one for phone calls/front camera videos, one for noise cancellation and one for the rear camera. Check that they aren't obstructed with dust, wax etc.

Small parts are notorious for being hit or miss. Can you confirm that the replacement port is functioning?

Esta resposta foi útil?

Sim Não

Pontuação 2

6 comentários:

Just put another board in out of interest and all works so guessing board trouble

28 de dez de 2016 por Niall

Did you look to see if there is LSD?

28 de dez de 2016 por Minho

How would I spot this?

28 de dez de 2016 por Niall

The connections cover was not on phone

28 de dez de 2016 por Niall

Look inside the standoffs (where the screws go) circled in red in this image. (iPhone 6 Logic Board Replacement)

You will need magnification to do this. Ideally a microscope but a jeweler's loupe will do. The bottom should look black. If it looks all scraped up, then it may have LSD.

28 de dez de 2016 por Minho

Exibir mais 1 comentário

Adicionar um comentário

Just put another board in out of interest and all works so guessing board trouble — Niall
Look inside the standoffs (where the screws go) circled in red in this image. (iPhone 6 Logic Board Replacement)

You will need magnification to do this. Ideally a microscope but a jeweler's loupe will do. The bottom should look black. If it looks all scraped up, then it may have LSD. — Minho