Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Introdução

Follow the steps in this guide to remove or replace the Pentalobe screws in an iPhone 7.

  1. Before you begin, discharge your iPhone battery below 25%. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured.
    • Before you begin, discharge your iPhone battery below 25%. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured.

    • Power off your iPhone before beginning disassembly.

    • Remove the two 3.4 mm pentalobe screws on the bottom edge of the iPhone.

    • Opening the iPhone's display will compromise its waterproof seals. Have replacement seals ready before you proceed past this step, or take care to avoid liquid exposure if you reassemble your iPhone without replacing the seals.

    Can anyone confirm 7/7P's pentalobe screws have a ring of seal near the screw head?

    Cooper Chase - Responder

    Confirmed, the screws have a black ring seal around the head.

    rcheing - Responder

    Can’t get the display front

    Bernadette Pfeifer - Responder

    From personal experience, I highly recommend before doing this procedure or any other, that you do a backup of your phone (preferably local) in case your procedure goes south.

    ballina5ny - Responder

    I purchased the repair tools with the replacement battery from iFixit. The tools include a screw driver and three heads none were labeled 3.4 mm. I think the one that fit the pentalobe screws was labeled Y000. The guide should identify the screw driver head supplied by the kit not 3.4mm.

    Mark Lieberman - Responder

    in the iphone 7 replacement battery kit from iFixit, the screwdriver that fits the 3.4 mm pentalobe screws is labeled P2 (and not Y000)

    Jan-Tijn Oppermann -

    the screwdriver PH000 does not work i wasted two screws and now they dont have the 4 cross mark they are now a circle, i buyed it all from Paraguay and it doesnt work, had to assembly back the parts because i got stuck like i mention with some screws, well im just going to send to a professional to install, thanks

    Martin Frutos, Nuñez - Responder

Conclusão

To reassemble your device, follow these instructions in reverse order.

38 outras pessoas concluíram este guia.

Evan Noronha

Membro desde: 05/02/2015

195.497 Reputação

178 Guias de autoria

Equipe

iFixit Membro de iFixit

Community

129 Membros

12.667 Guias de autoria

are there any water seals associated with the pentalobe screws? I blew compressed air into my iphone 7 and two tiny square rubber gaskets (~3mm) popped out. They squares have a round hole in them. I can only figure they are part of the pentalobe screw water seals, but I’m not sure, and I don’t know how to put them back in the phone to restore the water seal. Can anyone offer a solution?

Austin Taterka - Responder

@ataterka The screws themselves have a tiny ring-shaped rubber gasket on them. The two rubber squares you found slip onto the screw bosses. I don’t think those are needed for water sealing, and they’re not even included on newer models.

Jeff Suovanen -

Does iPhone 7 and iPhone 8 (including «Plus» models) share the same bottom pentelope screws?

Victor Rezai - Responder

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 8

Últimos 7 dias: 88

Últimos 30 dias: 419

Duração total: 24,892