Pular para o conteúdo principal
Ajuda
Editando passo 3 —

Tipo de Passo:

Arraste para reorganizar

The rear cover on this style of motor is held in place by four rivets that are compressed in to holes in the gear housing.

The rivets need to be drilled out just a little bit to weaken them enough to pry off the cover. Begin this process by drilling the rivets about 1/4" deep with a small drill bit, smaller than 1/8".

Repeat with all four rivets.

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.