Conserte seus objetos Comunidade Loja

The Xbox One S, designed by Microsoft Corporation, was released on August 2016. The Xbox One S is a redesign of the Xbox One.

428 Perguntas Visualizar todos

Opções

Issues with replacing HDMI port

Hello, I attempted a hdmi port replacement which I ripped out a few a pads. I however ran some jumper wires. However when connected to a tv it doesn’t display anything. When doing a continuity test pins 1,3,4,6,7,9,10,11,12, and 13 don’t seem to be grounded. Anyone know what I did wrong and how I can fix it?

Block Image

Block Image

Block Image

THE SHORTED COMPONENTS. As I stated I am unsure if they are supposed to be shorted. I don’t see a visible bridge of solder connecting them.

Block Image

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não
Pontuação 0
Adicionar um comentário

2 respostas

Filtrar por:
Mais úteis Mais recentes Mais antigas
Solução escolhida

Opções

take the port off and check the pins, if they are no longer shorted then its your soldering thats the issue, here are the readings you should be getting.

Block Image

Esta resposta foi útil?

Sim Não
Pontuação 1

1 comentário:

I ended up buying a new port. Which fixed the issue.

por

Adicionar um comentário
Pergunta mais útil

Opções

It looks like some pins were shorted - To be checked but if you have a multimeter you cloud to check if the pin you resolder is shorted or not...
If you look at the number "7" on the PCB, the pins 13 and 14 seams to touch.

following the tracks on the PCB I would try to test for continuity from the front of the connector to the nearest component.

Block Image

Esta resposta foi útil?

Sim Não
Pontuação 2

2 comentários:

So I decided to desolder the whole hdmi port and solder it back. I tested the connection from the components to pins and they all seemed to have continuity. However pin 1 and pin 2 seems to be shorted. I have no clue if they are supposed to be shorted as there is no visible connection. I have attached a picture which I highlight the other component that is also shorted. Also my tv recognizes something is plugged in, but doesn’t display anything.

por

If you use flux your solder will run better.

por

Adicionar um comentário

Adicionar a sua resposta

Emanuel será eternamente grato(a).
Exibir estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 4

Últimos 30 dias: 11

Duração total: 224