While replacing my front screen I disconnected the home button ribbon located under the speaker configuration. Now I can't get it to get back on to stay and work properly. How can I fix this?
Esta é uma boa pergunta?
Rep: 77,1 mil
337
104
145
it's a slide in connection with a lockbar..you need to flip up the tab/lockbar on the side that the flex will go in, then slide flex in on top of pins, when you feel resistance push the lock bar back down.
Esta resposta foi útil?
do you have a picture to show this or maybe a diagram?
I think that I may have taken the whole assembly off when I just needed to take the ribbon out. What disconnected was the connector. Do you think i broke it off beyond repair?
Rep: 931
8
5
1
the guide on here has the best pictures I could find:
Esta resposta foi útil?
+ step 31 onwards.. (luke the question asker) click on the photo and then you can "view huge" to see what we mean.
Rep: 931
8
5
1
iPhone 4 Dock Connector Replacement
is it possible you have removed the dock connector? this link is about 3/4 the way through the guide, I think this could be it.
Esta resposta foi útil?
no i don't think so, my problem is where you connect the home button ribbon. I took/broke the (i hate to use this word, but I'm lost in words) "thing" that the ribbon goes inside off. not until i played around with it saw that the ribbon comes out of this small piece. my problem is how do i correctly reconnect this piece?
Hi Luke, did you ever figure this out? I did the same thing :(
Esta resposta foi útil?
Últimas 24 horas: 0
Últimos 7 dias: 0
Últimos 30 dias: 0
Duração total: 1,548
