Ir para o conteúdo principal

Announced October 22nd and released November 12th, 2013. The iPad mini 2, also known as the iPad mini with Retina Display, has all the pixels of the iPad Air in a smaller 7.9" form factor.

426 Perguntas Visualizar todos

iPad Mini 2 Not Charging Looping Apple Logo

Hello I have an iPad Mini 2 CDMA model the ipad doesnt show a charging symbol or that battery symbol all it does is reboot to apple logo is like is not detecting the battery. I bought a new battery and same thing happens. I was about to buy a new charging port and solder it. But I want to know expert opinions first on what should I do first. If is board problem can you guide me where to measure with the multimeter?

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Pontuação 0
Adicionar um comentário

1 resposta

Solução escolhida

Your iPad is boot-looping; it may be a battery/charge problem but it could also be something else. If you have access to a USB Ammeter, you could use that to determine if the ipad is really drawing current when it says or is supposed to be charging.

You're replacement battery may also be sub-par...that is not uncommon for replacement batteries, especially if you bought one on eBay.

Try these things (if you haven't already) to see if anything helps:

  • Try a hard reset (Home & Power button for 10 secs)
  • Use a genuine Apple Lightning connector
  • Use a genuine Apple charging brick and let it charge overnight
  • Try to connect it to different computers (mac/pc if possible) with an updated iTunes
  • Put the iPad in recovery mode (search DFU Mode). Careful, this can reset your data
  • Use 3uTools for putting it in and out of Recovery Mode
  • Use 3uTools to flash the firmware (you can't downgrade)
  • Check the condition of all the flexes and connectors (with magnification)
  • Disconnect the LCD, Digitizer, Buttons and the camera completely from the logic board and see if iTunes will recognize the iPad as a bare bones unit and allow you to see it's contents. Follow this guide but no need to remove the antennas and whatnot, just use it for the connectors.

Otherwise, you may have a dock or logic board issue. If you are uncomfortable doing these steps, consider finding a repair shop to do the troubleshooting. A shop that also does micro-soldering can go deeper if the problem is not modular in nature.

Esta resposta foi útil?

Pontuação 1
Adicionar um comentário

Adicionar a sua resposta

Dustin será eternamente grato(a).
Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 3

Duração total: 1,311