looking the micro welds they seems to be all right but they doesn't work...is it possible to weld againg them or it's necessary to change all the part of mother board where the chargar attack is attached?
Esta é uma boa pergunta?
Rep: 782,8 mil
1,1 mil
893
2,3 mil
Kevin Santi, yes you can reflow the existing solder with a small soldering iron. Test your jack with a multimeter. Plug it in and test on the motherboard contacts, to make sure that you have power on that end. Hope this helps, good luck
Esta resposta foi útil?
Thank you very much =D
Últimas 24 horas: 1
Últimos 7 dias: 2
Últimos 30 dias: 2
Duração total: 428
