Ir para o conteúdo principal
Ajuda

Repairing a Nintendo DS that is not charging

Editando passo 2 —

Tipo de Passo:

Arraste para reorganizar

Remove the faulty EM10 filter. Use a soldering iron to melt the solder and gently lift off the filter with tweezers or pliers, being careful not to pull the copper tracks off the motherboard.

A replacement EM10 filter is available HERE (as at 01/01/12) no doubt other suppliers exist

Solder new EM10 filter into place, ensuring correct orientation. If required, check the new filter with a multimeter to confirm before installing.

Alternate method - Bridge the solder pads that correspond with each set of pads - yellow to yellow and cyan to cyan

Bypassing the EM10 filter may affect the system performance and is not recommended

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.