Participe da comunidade de reparos - Criar conta

Introdução

This page will guide you through the replacement of the motor block in your Hamilton Beach Classic Stand Mixer 64650. You may also find this guide useful to access many other parts in your mixer that you may be experiencing problems with. Although this guide will require the use of a soldering iron, there is a link provided to walk through the process step-by-step.

O que você precisa

Passo 1 Motor

Hamilton Beach 64650 Motor Replacement, Motor: passo 1, imagem 1 %32

Hamilton Beach 64650 Motor Replacement, Motor: passo 1, imagem 2 %32

Hamilton Beach 64650 Motor Replacement, Motor: passo 1, imagem 3 %32

Flip the handle on its side. Remove five 3.8 mm Philips #2 screws shown and set aside them aside.

Editar

Pergunte ao FixBot

Passo 2

Hamilton Beach 64650 Motor Replacement: passo 2, imagem 3 %32

Remove the four 8.6 mm Philips #2 screws securing the motor mount and place them aside.

Editar

Pergunte ao FixBot

Passo 3

Hamilton Beach 64650 Motor Replacement: passo 3, imagem 3 %32

Carefully pull the motor block out of the case.
Collect the two spring located on top of the white beater gears. The springs are held in place with compression, and may fall into the case when the motor is moved.
Handle the wires with care to ensure you do not break any of them.

Editar

Pergunte ao FixBot

Passo 4

Hamilton Beach 64650 Motor Replacement: passo 4, imagem 3 %32

Desolder the six wires connected to the motor using this guide.
Make sure to note colors when you disconnect them and remember where to reconnect them later.