Ir para o conteúdo principal

Hair Dryer Fan/ Motor Assembly Replacement

O que você precisa

  1. Hair Dryer Fan/ Motor Assembly Replacement, Nozzle: passo 1, imagem 1 %32 Hair Dryer Fan/ Motor Assembly Replacement, Nozzle: passo 1, imagem 2 %32
    • Remove the black air concentrating nozzle by gently twisting and pulling the nozzle.

    • If nozzle is not attached, skip to next step.

  2. Hair Dryer Fan/ Motor Assembly Replacement, Grating: passo 2, imagem 1 %32
    • Using a screwdriver, remove the screw located underneath the air concentrating nozzle. This screw attaches the hair dryer body to the hair dryer grating.

    • For most hair dryers, use a Phillips #1 screwdriver. For hair dryers with smaller screws, consider using a Phillips #00 screwdriver.

  3. Hair Dryer Fan/ Motor Assembly Replacement: passo 3, imagem 1 %32
    • Detach the hair dryer grating from the body by gently twisting the grating from side to side.

  4. Hair Dryer Fan/ Motor Assembly Replacement: passo 4, imagem 1 %32
    • Separate the hair dryer grating into the three pieces seen in the image.

  5. Hair Dryer Fan/ Motor Assembly Replacement, Fan/ Motor Assembly: passo 5, imagem 1 %32
    • Locate the screws on the handle and remove with a Phillips screwdriver.

  6. Hair Dryer Fan/ Motor Assembly Replacement: passo 6, imagem 1 %32
    • Carefully separate the plastic case with the Plastic Opening Tool.

  7. Hair Dryer Fan/ Motor Assembly Replacement: passo 7, imagem 1 %32
    • After removing the plastic case, locate the fan towards the back of the hair dryer.

  8. Hair Dryer Fan/ Motor Assembly Replacement: passo 8, imagem 1 %32
    • Remove the screw that is holding the fan to the motor using a Phillips screwdriver.

  9. Hair Dryer Fan/ Motor Assembly Replacement: passo 9, imagem 1 %32
    • Remove the screws holding the motor to the casing using a Phillips screwdriver.

    • NOTE: This may be unnecessary if the fan can be removed without using a screwdriver.

  10. Hair Dryer Fan/ Motor Assembly Replacement: passo 10, imagem 1 %32
    • Isolate the fan from the rest of the dryer.

    • Remove the screws holding the motor in place. Replace with the new component.

  11. Hair Dryer Fan/ Motor Assembly Replacement: passo 11, imagem 1 %32
    • Solder the wires to the motor. Refer to the soldering page below, which will help you replace this component.

    • Soldering Skills

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas executaram este guia.

Mitch

Membro desde: 10/04/12

34 Reputação

Autoria de 5 guias

Equipe

Cal Poly, Team 24-29, Regan Fall 2012 Membro de Cal Poly, Team 24-29, Regan Fall 2012

CPSU-REGAN-F12S24G29

Membros da 5

Autoria de 6 guias

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 3

Últimos 7 dias: 15

Últimos 30 dias: 69

Duração total: 15,815