Ir para o conteúdo principal

Introdução

This guide shows the steps required to replace the vibration motors in a PS3 Wireless Afterglow Controller.

Peças

Nenhum componente especificado.

  1. Afterglow Wireless PS3 Controller Vibration Motor Replacement, Back Cover: step 1, image 1 of 2 Afterglow Wireless PS3 Controller Vibration Motor Replacement, Back Cover: step 1, image 2 of 2
    • Lay the controller face down on a flat surface and remove the seven 9mm Phillips #0 screws on the back of the controller.

    • Lift up and remove the controller back plate.

  2. Afterglow Wireless PS3 Controller Vibration Motor Replacement, Vibration Motor: step 2, image 1 of 2 Afterglow Wireless PS3 Controller Vibration Motor Replacement, Vibration Motor: step 2, image 2 of 2
    • Carefully remove the battery by lifting it straight up from its place.

    • Keep in mind that the red and black battery wires are attached to the motherboard. Handle these with care.

  3. Afterglow Wireless PS3 Controller Vibration Motor Replacement: step 3, image 1 of 1
    • Unscrew the four 9mm Phillips #0 screws that are attached to both joy stick control mini-motherboards. There are two screws for each mini-motherboard.

  4. Afterglow Wireless PS3 Controller Vibration Motor Replacement: step 4, image 1 of 3 Afterglow Wireless PS3 Controller Vibration Motor Replacement: step 4, image 2 of 3 Afterglow Wireless PS3 Controller Vibration Motor Replacement: step 4, image 3 of 3
    • Jiggle both joy stick control mini-motherboards out of their holding place.

    • Set aside the mini-motherboards so that the vibration motor wire connections are accessible.

  5. Afterglow Wireless PS3 Controller Vibration Motor Replacement: step 5, image 1 of 2 Afterglow Wireless PS3 Controller Vibration Motor Replacement: step 5, image 2 of 2
    • Pull both vibration motors straight up from their holding place.

  6. Afterglow Wireless PS3 Controller Vibration Motor Replacement: step 6, image 1 of 1
    • Use the soldering tool to heat the solder connecting the red and black vibration motor wires to the motherboard to detach the vibration motors.

    • Use this guide for further details on how to solder.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Natalie Cox

Membro desde: 17/02/2017

204 Reputação

2 Guias de autoria

Equipe

USF Tampa, Team S19-G5, Hoffman Spring 2017 Membro de USF Tampa, Team S19-G5, Hoffman Spring 2017

USFT-HOFFMAN-S17S19G5

4 Membros

14 Guias de autoria

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 2

Últimos 30 dias: 6

Duração total: 621