Few days ago I replaced the touch screen and the shell of my Switch. However, after putting everything together the screen of my switch stays in black (can see light on the back). I tried to disconnect and connect again the cables of the LCD but nothing happen, it stayed the same. I send you here some picture if you can tell me if there's any issues on the cables or connections. Thanks.
Esta é uma boa pergunta?
Rep: 16 mil
20
12
20
Hi!
Connector and cable looks fine. It's possible that something inside the cable is broken and thus need an replacement.
How is the smaller ribbon cable (The one which is fused with the screen) connected? Is it all the way in?
Could also be something which is not connected properly. Please check all the cables and connectors.
Esta resposta foi útil?
I disconnected and connected at least three times the screen connector and some other connectors too. However, with your answer I came with the conclusion that I probably did brake or damage the LCD ribbon cable. Thanks.
No problem! It’s probably something inside the cable (which you just can’t see)… please let us know if a new LCD fixed it! Thanks!
Rep: 34,9 mil
10
23
44
on the second photo 3rd pin from the right looks like its missing
Esta resposta foi útil?
You can see in the last picture that the pin is there. Thanks anyway.
Últimas 24 horas: 0
Últimos 7 dias: 7
Últimos 30 dias: 40
Duração total: 40
