My series 500 washes spins drains then instead of going to complete or done it starts sensing and filling with water again. It will run forever unless you unplug it. If you plug it back in it will automatically start a wash cycle again. I have ran the calibration several times.
Esta é uma boa pergunta?
Rep: 450,2 mil
11
367
1,4 mil
Here's the Tech sheet for the washer that may help.
Run the diagnostics as shown on p.2 and check if any error codes are displayed.
There's a table on the bottom right of p.3 that shows how to interpret the status LEDs to know what the code is.
The fault error code and description are shown on p.6-p.7.
Hopefully a start in finding out what's happening.
Esta resposta foi útil?
Últimas 24 horas: 2
Últimos 7 dias: 12
Últimos 30 dias: 89
Duração total: 343
Hi @scottmason18891,
What is the model number of the washer?
por jayeff
Model 11025102310 Kenmore series 500.
por Scott Mason