Dryer stopping and blinking lights

There are a couple reasons it may shut down. The motor may be overheating. You can check by turning on the dryer and wait for it to shut down, try immediately restarting the dryer. if it wont start then wait ten minutes and try again. if it starts then more than lijkely the motor is overheating. another is a moicture sensor telling the dryer there is too much moisture in the dryer. If it will run empty without shutting down, more than likely a bad moisture sensor. A bad belt which if the drum turns its not the belt. Try the lint filter and make sure it is clean. Good luck

Mine is doing the same thing. I had it fixed but it's still doing it. I thought it was the off switch because the button was tight in the hole. I also have to turn the control button all the way around back to where I had it or put it on a different setting. Sometimes when I turn it on it will run for about a minute then stop. If I walk away from it and I don't hear it go off, I don't know if it does it anytime through the cycle or not. I was just wondering if it may be the circuit board behind it. Later I'll check the clothes and they are still damp.