My temperature adjustment knob just quit. Thanks to this site I know I have to replace the rotary encoder for the temperature control dial and have ordered the correct the part, thanks to Roger. The circuit board had three of these encoders (Temperature, Function, and Pizza). I don't know which encoder location is for which control. Can somebody identify which is which? RS101, RS102, RS103
Esta é uma boa pergunta?
Rep: 450,6 mil
11
367
1,4 mil
Hi @ambimom,
Don't know the toaster oven but usually an encoder has a shaft that the knob is affixed to, so if the board was in position the shaft would protrude through the case where the knob would then be attached and hopefully it is marked on the case as to its function.
Its location on the board should match the holes in the oven case so this will indicate which one it is.
(click on image)
Esta resposta foi útil?
Últimas 24 horas: 1
Últimos 7 dias: 5
Últimos 30 dias: 15
Duração total: 87
