Generic ttl outputs for the drawers and bins

Question

Omnicell Anesthesia Workstation

Repair guides and service information for Omnicell Anesthesia Workstation (AWS) - an automated anesthesia medication dispensing system. There are several versions of the device: G3, G4, and XT Anesthesia Workstation.

1 Perguntas Visualizar todos

Steven Rose @stevenrose50747

Rep: 1

Postado: 3 de fev de 2023

Opções

Generic ttl outputs for the drawers and bins

Can I use a generic device to operate the drawer locks and bins, without going through the proprietary software? I purchased a surplused G4,

I am using the G4 as a hardware container!

Responder a esta pergunta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não

Pontuação 0

Adicionar um comentário

1 resposta

oldturkey03 @oldturkey03 Rep: 783,8 mil 1,1 mil 894 2,3 mil · Answer 1 · 2023-02-03T13:20:07-07:00

oldturkey03 @oldturkey03

Rep: 783,8 mil

1,1 mil

894

2,3 mil

Postado: 3 de fev de 2023

Opções

Steven Rose if it is anything like the Pyxis I have been working on, there is not really a good way. The addresses for the drawers etc. are all part of the software. Without the software, you do not get the desired drawer opening etc. unless you can code and write it yourself. You will need the right addresses for the drawers etc.

Esta resposta foi útil?

Sim Não

Pontuação 0

Adicionar um comentário

Omnicell Anesthesia Workstation

Generic ttl outputs for the drawers and bins

1 resposta

Adicionar a sua resposta