Z, RZ, and Slider not working after repairing a severed USB cable.
My dog had chewed through the primary USB cable for my Controller. I made two attempts at soldering the wires back together and covered each exposed wire individually with heat shrink tubing.
However in both cases, while the general flight control of the joystick, and most buttons are restored to functionality; the Slider for the Throttle and the Twisting Roll actions of the joystick are completely unresponsive. I'm am unclear on what I am missing when repairing the cable. Is it possible the aluminum insulation sleeve found under the first layer of cable covering, is a contributing factor? Any help would be appreciated.
Esta é uma boa pergunta?