I have a similar problem with our MVWB65FW3 commercial washer. I start the washer, light on Sensing turns on and drum spins very slowly 2-3 cycles before it goes to Wash cycle but immediately stops and returns to sensing. Repeats this cycle 4-5 times before it finally turns off. Takes a while before Lid Lock releases.
Esta é uma boa pergunta?
Rep: 458 mil
11
370
1,4 mil
Hi @smileynv
Here's the Tech sheet for the washer (assuming you meant MVWB765FW3?).
Run the diagnostics as described in the sheet and check what error codes are shown. The sheet shows the most likely causes for each error code.
Hopefully a start
Esta resposta foi útil?
Últimas 24 horas: 2
Últimos 7 dias: 10
Últimos 30 dias: 17
Duração total: 59
2 comentários
Did you ever finf out how to fix your washer, im having the same problem. I havr the same model as yours
por Sandra Gonzalo
@sandragonzalo
What does performing the diagnostic tests show, if anything? See the Most Helpful Answer below.
por jayeff