Major components (bottom cover, battery, wheels, brush assembly) are easy to remove & replace. However, I believe I need to clean connections at the main board below the top cover to repair my Roomba. I don’t see an obvious way to get the cover off. Any help?
Esta é uma boa pergunta?
Rep: 782,4 mil
1,1 mil
893
2,3 mil
@potterra you need to remove the bumper. Then disconnect the ribbon cable from the bumper before you remove it completely. Take a look at this video and use that as a general guide since it is not the same model as yours.
Esta resposta foi útil?
Últimas 24 horas: 1
Últimos 7 dias: 6
Últimos 30 dias: 19
Duração total: 158
